Installation Instructions

5
INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE
5.6 CAPACITY
Install anti-tip bracket
IMPORTANT SAFETY WARNING!
Toreducetheriskoftippingoftherange,therange
mustbesecuredtotheoorbyproperlyinstalledan-
ti-tipbracketandscrewspackedwiththerange.Fail-
uretoinstalltheanti-tipbracketwillallowtherangeto
tipoverifexcessiveweightisplacedonanopendoor
or if a child climbs upon it. Serious injury might result
from spilled hot liquids or from the range itself.
Ifrangeisevermovedtoadifferentlocation,the
anti-tipbracketmustalsobemovedandinstalledwith
the range.
Instructionsareprovidedforinstallationinwoodor
cementfastenedtoeithertheoororwall.When
installedtothewall,makesurethatscrewscompletely
penetratedrywallandaresecuredinwoodormet-
al.Whenfasteningtotheoororwall,besurethat
screwsdonotpenetrateelectricalwiringorplumbing.
Anti-tip bracket installation instructions
a. Locate the bracket using the template-(Bracket
may be positioned on either the left or right side of the
range.RefertoFigs.4,5,&7topositionthebracketif
templateisnotavailable).
 Marktheoororwallwhereleftorrightsideofthe
range will be located. If rear of range is against wall
ornofurtherthan1-1/4”fromwallwheninstalled,you
mayusethewalloroormountmethod.Ifmolding
isinstalledanddoesnotallowthebrackettotush
againstwall,removemoldingormountbrackettooor.
 Forwallmount(Fig.4),locatethebracketbyplacing
the back edge of the template against rear wall
and the side edge of template on the mark made
referencing the side of the range. Place bracket on
top of template and mark location of the screw holes
inwall.Ifrearofrangeisfurtherthan1-1/4”fromwall
wheninstalled,attachbrackettotheoor(SeeFig.5).
Fig.4
Fig.6
Fig.5
Fig. 7
1
 Foroormount,locatethebracketbyplacingback
edge of the template where the rear of the range will
be located. Mark the location of the screw holes shown
in template.
b. Drill pilot holes & fasten bracket-Drill1/8”pilothole
wherescrewsaretobelocated(Fig.6).Ifbracketisto
be mounted to the wall, drill
pilotholeatanapproximate
20° downward angle. If
bracket is to be mounted to
masonryorceramicoors,
drill3/16”pilothole1-3/4”
deep. The screws provided
may be used in wood or
concrete material. Use
5/16”nut-driverorathead
screwdriver to secure the
bracket in place.
c. Level & position range - Level range by adjusting the
(4)levelinglegswithawrench.
Note: A min. clearance of 1/8” is required between bottom
of range and leveling legs to allow room for bracket.
 Sliderangebackintoposition(Fig.7).Removelower
panel or storage drawer to visually check that rear
leveling leg is inserted into and fully secured by the
bracket. For models with a warmer drawer or broiler
compartment, grasp the top rear edge of the range
and carefully attempt to tilt it forward.