Welcome & Congratulations Congratulations on your purchase of a new range! At Electrolux Home Products, we are very proud of our product and are completely committed to providing you with the best service possible. Your satisfaction is our number one priority. We know you’ll enjoy your new range and Thank You for choosing our product. We hope you consider us for future purchases.
Important Safety Instructions Read all instructions before using this appliance. Save these instructions for future reference. This manual contains important safety symbols and instructions. Please pay attention to these symbols and follow all instructions given. This symbol will help alert you to situations that may cause serious bodily harm, death or property damage. This symbol will help alert you to situations that may cause bodily injury or property damage.
Important Safety Instructions • Never Leave Surface Burners Unattended at High Heat Settings—Boilovers cause smoking and greasy spillovers that may ignite, or a pan that has boiled dry may melt. • Protective Liners—Do not use aluminum foil to line surface burner pans, or oven bottom, except as suggested in this manual. Improper installation of these liners may result in risk of electric shock, or fire.
Setting Surface Controls Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or wood spoons could catch fire if placed too close to a flame. In the event of an electrical power outage, the surface burners can be lit manually. To light a surface burner, hold a lit match to the burner head, then slowly turn the Surface Control knob to LITE.
Before Setting Oven Controls Oven Vent Location The oven vent is located below the backguard. When the oven is on, warm air is released through this vent. This venting is necessary for proper air circulation in the oven and good baking results. DO NOT BLOCK THE OVEN VENT. Arranging Oven Racks ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE OVEN). Always use oven mitts when using the oven. Removing & Replacing Oven Racks To remove, pull the rack forward until it stops.
Oven Control Functions Note: The time of day must first be set in order to operate the oven. Changing the Temperature Display Mode (some models) The electronic oven control temperature display mode was factory preset to display (Fahrenheit) °F oven tempertaures. Note: Oven cooking temperatures may be set from 170°F to 550°F (77°C to 287°C). To change the Temperature Display Mode to °C (Celsius) or from °C to °F (do not use Bake or Broil while changing the Temperature Display Mode): 1.
Setting Oven Controls Note: The time of day must first be set in order to operate the oven. To Set or Change the Temperature for Baking The oven can be programmed to bake at any temperature from 170°F to 500°F. To Set the Controls for Baking: 1. Press . "— — —°" appears in the display. 2. Within 5 seconds, press the or . The display will show "350°F." By pressing and holding the or the temperature can then be adjusted in 5°F increments. 3.
Setting Oven Controls Note: The time of day must first be set in order to operate the oven. To Broil 1. 2. 3. 4. Slide broiler drawer out to the stop position. Remove broiler pan & insert (See Fig. 1). Position rack before setting control; while range is cool. Position rack by tilting front of rack up & pulling rack out from locating holes in rear of broiler drawer.
Adjusting Your Oven Temperature (some models) Your new oven has been factory calibrated and tested to ensure an accurate baking temperature. For the first few uses, follow your recipe times and temperature recommendations carefully. If you feel your oven is too hot or too cool from your baking experience, the oven temperature may be adjusted to your liking. Note: DO NOT adjust your oven temperature based on oven thermometers, such as those found in grocery stores, they may not be accurate.
General Care & Cleaning (Cleaning Chart) Surfaces How to Clean Aluminum (Trim Pieces) & Vinyl Glass, Painted Plastic Body Parts & Control Knobs Use hot, soapy water and a cloth. Dry with a clean cloth. For general cleaning, use hot, soapy water and a cloth. For more difficult soils and built-up grease, apply a liquid detergent directly onto the soil. Leave on soil for 30 to 60 minutes. Rinse with a damp cloth and dry. DO NOT use abrasive cleaners on any of these materials; they can scratch.
To Clean the Recessed and Contoured Areas of the Cooktop - If a spill occurs on or in the recessed or contoured areas, blot up spill with an absorbent cloth. Rinse with a clean, damp cloth and wipe dry. To Remove and Replace the Surface Burner Caps and Surface Burner Heads - Remove in the following order: (1st) surface burner grate, (2nd) surface burner cap, (3rd) surface burner head and (4th) surface burner drip pan (some models).
General Care & Cleaning Removing & Replacing the Oven Door (all models) The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down. Fig. 1 Fig. 2 Fig. 3 To Remove Oven Door: 1. Open oven door completely (horizontal with floor - See Fig. 1). 2. Remove 2 screws located on the inside of the oven door liner (See A Fig. 2). 3. Insert the 2 screws into the door hinge holes located on the side of the hinge arm, one into each hinge (See B Fig. 2). 4.
Before You Call Solutions to Common Problems Before you call for service, review the following list. It may save you time & expense. The list includes common occurrences (shown in bold) that are not the result of defective workmanship or materials in this appliance. The possible corrections to these problems are provided with the problem listed: Range is not level - (1) Poor installation. Place oven rack in center of oven. Place a level on the oven rack.
Notes 15
Major Appliance Warranty Information Your appliance is covered by a one year limited warranty. For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions. Exclusions This warranty does not cover the following: 1.