Owner's manual

1. Insert the included triangular key (A) into the bore hole on the
bottom side of the PULVERISETTE 7 classic line and turn it to the
right.
2. Unlock the latch (2) by turning it.
3. Pull the hood (3) up to open it.
4. The mill can only be switched on again if the hood (3) is closed and
the safety lock (7) has been enabled again by turning the trian-
gular key to the right.
2.6.2
Imbalance switch
The device switches off if there is excessive imbalance. In this case the
second grinding bowl has to be filled accordingly.
NOTICE!
The maximum permissible weight difference is about 70 g
for long-term loading; 100 g is permissible for short-term
loading.
CAUTION!
The imbalance switch can be disabled at your own risk. The
Fritsch company will give no guarantee for damage
resulting from disabling of the imbalance switch.
NOTICE!
Change these settings only after all work as described in
Ä Chapter 4 ‘Installation’ on page 20 has been carried out!
In the factory setting, the imbalance switch is activated!
Activation / deactivation of the imbalance switch in setup mode:
Safety information and use
- 14 -