Owner's manual

5 Initial start-up

Perform initial start-up only after all work as described in

Chapter 4

‘Installation’ on page 20 has been carried out.

5.1 Switching on

n The device must be connected to the power supply if this has not

been done already.

n Switch on the device with the main switch (8) on the back of the

device.

n The POWER SUPPLY lamp lights up.

5.2 Function check

CAUTION!

Only perform the function check at a speed of 100 1/min.

Use two empty grinding bowls of equal weight to prevent

too great an imbalance.

n Open the hood (3).

n Clamp two empty lidded grinding bowls with of the same weight.

n Close the hood (3).

n Set the speed on the control panel as 100 1/min. (see

Chapter 6.8

‘Setting the speed’ on page 37)

n Press START on the control panel.

n The hood (3) is locked and the mill starts up at the preselected

speed.

Initial start-up

- 26 -