Owner's manual

6 Using the device
CAUTION!
Before starting the machine, make sure that the grinding
bowl has been clamped correctly and that there are no
loose parts inside the device. There is a risk of loose
grinding bowls or parts being projected. Failure to observe
this will render void the guarantee, and releases us from
liability for any resulting damage to the device as well as for
any resulting personal injury.
NOTICE!
During grinding, the temperatures in the grinding bowl may
get very high.
In encased grinding bowls, the inserts are glued into the
casing with a two-component construction adhesive.
The adhesive is resistant to temperatures up to approx. 140
°C. Above 140 °C, the adhesive will liquefy and accumulate
below the insert in the casing. When the adhesive cools
down, it solidifies and pushes the casing up. That can cause
irreparable damage to the insert. The grinding bowl will
definitely be rendered unusable.
Above temperatures of 200 °C, the adhesive will be
destroyed. The same applies for encased grinding bowl lids.
V‐belt, seals, and motor require some time at the beginning
before they can reach the optimal performance and/or
speed. This means that initially a well‐filled and heavy
grinding set may operate at a lower speed than after an
introductory phase of approx. 1 ‐ 2 hours running time.
6.1 Choice of grinding bowls and grinding balls
CAUTION!
If the grinding elements used are not genuine accessories,
we assume no guarantee and exclude all liability for
damage to the device or for personal injury.
Using the device
- 28 -