Owner's manual

13 Spindle screw
14 Lock nut
Clamping
n Place the sealing ring and the lid onto the bowl.
n Place the grinding bowl in the grinding bowl holder on the cork disc;
do not force it!
n Turn the spindle screw (13) all the way down until the pressure piece
of the rubber disc lies flush on the lid.
n Screw the spindle screw by hand until tight.
n Turn the lock nut (14) all the way down until it lies flush on the
clamping bracket.
n Tighten the lock nut by hand.
DANGER!
After several minutes of grinding and in the cooling-down
phases, check that the spindle screw and the lock nut are
still firmly connected.
6.6 Mass balance
For mass balancing always clamp a bowl with a lid and sealing ring of the
same weight opposite as a counterweight. This bowl can be empty
(without balls or grinding stock), if the weight difference does not exceed
70 - 100 g.
NOTICE!
If the weights of the bowls differ too much, this may result
in the planetary micro mill shifting position on the sup-
porting surface.
6.7 Grinding duration
WARNING!
Burn hazard!
Grinding bowls can get very hot after long grinding dura-
tions. Wear protective gloves for removal after grinding or
during the grinding breaks.
Depending on the application, the grinding duration should be adapted
to the development of heat in the bowls. The temperature inside the
bowls is 20 - 30 °C warmer than the outer casing temperature.
Using the device
- 35 -