Instructions / Assembly

Assembly Instructions
Comfort Park Ave Bench
8 FT
Components
Tools for Assembly: Powered Driver, Ratchet & 7/16 Socket
(4) Bench Bases
(2) Bullnose Slats
(36) Hex Lag Screws
(36) Flat Washers
Step by Step Assembly
Before you begin: Check components to verify all are included. Assembly will require two people and must be performed on a level
and smooth surface. Do not overtighten hardware as damage can occur.
Step 1
As of 08/2019
(5) Seat & Back Slats
With two people, position bench bases upright and parallel
to each other. Align the front bullnose slat (2 holes) with
the pre-drilled holes in each bench base. Attach using hex
lag screws and flat washers. Repeat for upper bullnose slat,
See Illustration ‘A’.
Illustration 'A'
Step 2
Align seat board holes with pre-drilled holes in bench bases,
attach using hex lag screws and flat washers. Repeat for
remaining seat and back slats, See illustration ‘B’. Ensure all
hardware is tight, but do not over-tighten.
Illustration 'B'
Cleaning Tips
Frog Furnishings products are durable and designed to last a lifetime, like most things that spend the majority of time outdoors,
sometimes they need a little cleaning. In most cases, all a Frog product requires is mild dish soap, a bucket of warm water and a clean
cloth. Apply the soapy mixture to scrub away the dirt and then rinse with water. If you have some stubborn dirt down in the grooves
and divots, mix 1 part bleach to 2 parts water, apply with your clean cloth, scrub with a soft bristle brush if needed and then rinse.