User's Manual

Do not use additional attachments other than those recommended or provided by the manufacturer
unless otherwise specified.
Do not submerse the controller in water or expose the controller to heavy moisture.
Do not operate the controller in or near water.
Do not operate the controller with wet hands.
Do not use the controller in any way other than its intended use.
Do not use the controller if damaged in any way.
Do not disassemble any part of the controller.
This product contains small parts that may cause choking if swallowed. Not intended for use by
children under 3 years of age.
Keep away from areas where dirt or liquid can get into the controller.
Keep away from direct sunlight and extreme temperatures.
Store in areas away from dust and humidity.
Use a dry cloth to clean the controller; never use chemicals.
NOTE:
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
MODIFICATIONS WILL VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
Caution content: changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC ID: TAZ2833
MADE IN CHINA
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and