Installation Guide

STEP 1 Check Package Contents
1 jamb cover - header
1 brickmould header
2 jamb cover sides (1 left & 1 right)
2 brickmoulds sides (1 left & 1 right)
1 screw package
STEP 2 Secure Wood Frame
Using 3" drywall screws (not supplied), screw through both door frame jambs into
house framing studs to secure frame (many door frames are only secured with nails
through the brickmould - this must be corrected as the wood brickmould is being replaced).
It is important to make sure the door is secure in the opening before
removing the current wood brickmould.
Images A & B Remove the current wood brickmould with a hammer and a pry bar.
CAUTION - not to damage the siding when removing the wood brickmould.
A B
Section A
STEP 3 Measure & Cut Aluminum Jamb Cover Header
Image C Measure the width of the header
C
from the inside of one side jamb
to the inside of the other side jamb.
Retro Clad Installation Instructions
Section A - Single Door
Installation Videos Available at - www.frontlinebldg.com
Be careful not to damage
siding while removing the
wood brickmould.
Measure the interior of
the door frame.
Rev. 04.22.16 Form 32508 Page A-2