Installation Guide

Images D & E Transfer this measurement to the aluminum jamb cover for the header. Use a
wood block to support the aluminum jamb cover while cutting (image E) on the saw.
D E
Image F The two locking points on the jamb cover should be facing up. Re-cut one of the
factory miter cuts to the length you have measured (use the factory miter as a template).
Note: A compound miter saw is recommended for the miter cuts.
F
STEP 4 Apply Aluminum Jamb Cover Header
Image G Holding the header jamb cover in place, push the jamb cover hard inward toward
the entry door. This will compress the jamb cover tight to the wood jamb. Attach
header jamb cover to existing wood with the pan head screws provided through
the pre-drilled holes.
G
Wood block supports
aluminum jamb cover
while being cut.
Locking points up
Wood support block
Screw to door jamb between
the jamb cover locking points
with pan head screws.
Transfer the dimension from
the wood jamb header.
Rev. 04.22.16 Form 32508 Page A-3