Installation Guide

STEP 7 Measure & Cut Aluminum Brickmould Head Casing
Note: If using wide casing please refer to their installation instructions in Section C
Image M Hold the header brickmould casing up to the locking legs of the header jamb
cover, mark one end with a pencil to the exact size of the header jamb cover.
(make sure that the miter on the opposite end is lined up with the miter on the jamb cover)
Image N Re-cut one mitered end of the brickmould casing to fit your door header.
M N N
STEP 8 Apply Aluminum Brickmould Head Casing
Image O
O
Align the header brickmould casing locking
legs with header jamb cover locking legs.
Miters of both casing and header jamb cover
need to be in alignment.
Then, using a rubber mallet, tap nosing onto
jamb cover locking legs.
STEP 9 Measuring & Cutting Aluminum Brickmould Side Casing
Image P Measure from the top of the header brickmould to the bottom of the sill on both
the left and right sides of the door jamb. Transfer the dimensions to the bottom of
each side brickmould casing and cut the brickmould to the proper length.
Image Q Re-cut the bottom of both side brickmould casings to fit your door.
P Q
The brickmould casing
snaps onto the locking legs
on the jamb covers.
Rev. 04.22.16 Form 32508 Page A-5