G-RX8- manual

Introduction
Thank you for purchasing FrSky G-RX8 8/16ch telemetry receiver. In order to fully enjoy the benefits of this system, please read the instruction manual carefully
and set up the device as described below.
FrSky 2.4GHz ACCST G-RX8 Manual
FrSky Electronic Co., Ltd www.frsky-rc.com Contact us : frsky@frsky-rc.com
Add:F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: sales4tech@gmail.com
Specifications
• Dimension: 55.26mm×17mm×8mm (L × W × H)
• Weight: 5.8g
• Number of Channels: 16CH (1~8ch/9~16ch from conventional channel outputs, 1~16ch from SBUS port ).
• Operating Voltage Range: 3.5V~10V
• Operating Current: 100mA@5V
• Operating Range: full range
• Firmware Upgradable
• Compatibility: D16 mode
• Servo frame rate: 9ms (HS--High Speed Mode)
18ms (FS--Normal Speed Mode)
Overview
Smart Port (S. Port) is a signal wire full duplex digital transmission interface developed by FrSky Electronic Co., Ltd. All
products enabled with Smart Port (including XJT module, RX8R receiver, new hub-less sensors, new Smart Dashboard, etc), serial
port user data and other user input/output devices can be connected without limitations for numbers or sequences at a high transmis-
sion speed.
1-6CH
F / S
L E D
CH1
CH2
CH3
CH4
CH5
CH6
S.BUS I N
CH7
S.BUS O UT/CH8
G-RX8
8 / 16CH TELEM ETRY
-
+
AIN2
S.Port
R
G
B
Features
2. G-RX8 supports the redundancy function for the master and slave receivers. The master receiver receives SBUS signal from the slave receiver. The master receiver
can be G-RX8, and the slave receiver can be receiver with SBUS output (for example, FrSky X8R, X6R, X4RSB, XSR, XM, XM+, R-XSR, G-RX8, L9R, etc) .
1. Variometer sensor: the measures range is -700m-10000m with the precision of 0.1m (high precision version), support altimeter (the rate range is +-16.7m/s) .
1-6CH
F / S
L E D
CH1
CH2
CH3
CH4
CH5
CH6
S.BUS I N
CH7
S.BUS O UT/CH8
G-RX8
8 / 16CH TELEM ETRY
-
+
AIN2
S.Port
R
G
B
Note: Make sure telemetry is disabled on the slave receiver when the slave receiver is a FrSky X series receiver. XM+ is recommended as the
slave receiver.

Summary of content (2 pages)