User Manual

31/07/12 12:25 PM
Page 5 of 13http://www.rchacker.com/projects/turnigy-9x/frsky-dht-module-ins…n?tmpl=%2Fsystem%2Fapp%2Ftemplates%2Fprint%2F&showPrintDialog=1
I connected the main board back up to the back then traced the power ground and ppm lines to the back of the main
plug on the main board. Bit of a mouth full that. I'd suggest checking it yourself just in case you have a different 9X
version.
A reminder of which are which.
Black - GND
Red - Power
Yellow - ppm
Here is the view of the back of the main board with the DHT wires soldered on.
Counting from the right, If ground is pin number 1 then the red wire is pin number 6 and the yellow wire pin number 7.
And a view of the main plug on the front of the main board with the DHT wires.