Archer R8 Pro - Manual

Instruction Manual for FrSky ARCHER GR8 Receiver
Version
1.0
Introduction
LED state
Green LED
On
Flash
On
On
On
Off
Red LED
On
Flash
On
Off
Off
On
Status
Register
Register successfully
Bind
Bind successfully
Working normally
Failsafe
Specifications
● Dimension: 47*26*15mm (L*W*H)
● Weight: 13g
● Number of Channels:
- 8 high-precision PWM channels
- 16 SBUS channels
- 24 SBUS channels (Stay tuned)
● Operating Voltage Range: 3.5-10V
● Operating Current: ＜55mA@5V
● Control Range: Full range* with telemetry
(*Full Range: ＞2km, range may vary based
on local conditions.)
● Voltage Measurement Range via AIN2
(External device): 0-36V
(Battery Voltage Division Ratio: 1:10）
● Compatibility: All FrSky ACCESS transmitters
Version
1.1
Instruction Manual for FrSky ARCHER R8 PRO Receiver
FrSky Electronic Co., Ltd. www.frsky-rc.com Contact us : [e-mail]
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: [e-mail]
01140165
The Archer R8 PRO has 8 high-precision PWM channel outputs and features excellent Anti-interference performance when
it comes to spark-ignition on internal combustion models. It supports full-range signal strength with dual detachable
antennas that assure optimal antenna reception and maximum range. In addition to all this, the R8 Pro can also be used as
a redundancy receiver along with any other FrSky ACCESS capable receiver equipped with a SBUS port.
All of the Archer receivers are hyper-matched with the ACCESS protocol. They not only feature wireless firmware upgrades,
increased range, and telemetry performance, the R8 PRO now supports more functions like configurable telemetry power,
S.Port/F.Port switching and FLR output. Additional valuable features are under development to unlock the true potential of
the ACCESS protocol.
Features
● ACCESS Protocol with Over The Air (OTA)
● Receiver redundancy
● 8 high-precision PWM channels
● SBUS IN &OUT (using standard servo connectors)
● S.Port / F.Port and AIN2 (on 4 pin socket)
● VFR (Valid Frame Rate) telemetry
● Anti-interference in spark-ignition
Overview
2
8/24CH Telemetry
R 8 PRO
BUTTON
Registration & Automatic binding (Smart Match )
Follow the step below to finish the Registration & binding procedure:
1. Put the transmitter/transmitter module into [Reg] status.
1.1 For Taranis X-Lite Pro as an example, turn on the transmitter, go to the MENU-MODEL SETUP-PAGE 2,choose
Internal or External RF, and select [Reg].
2. Connect the battery to the receiver while holding the button on the receiver. The RED LED and GREEN LED on the
receiver will be on, indicating into the [Reg] status. Select [ENTER] on the transmitter, The RED LED and GREEN LED on
the receiver will flash, and the transmitter displays [Registration ok].
3. Turn off the receiver.
4. Move the cursor to select the receiver 1 [Bind].
5.
Connect the battery to the receiver, the GREEN LED will flash, indicating into the [Bind] status. Select the RX, the GREEN
will keep lit, and the transmitter displays [Bind successful].
6. The transmitter exit [Bind], GREEN LED will keep lit, RED LED will be off, indicating Working normally.
TM
Note: Once the receiver is registered, the button is not needed anymore in the binding process.