Operating Manual

PrimAer 28GHz Operating Manual

4. Use rubber hammer to fix anchors to the holes drilled on the wall.

Figure 19. SU Wall Installation Assemble

Above picture is an assembly drawing of the SU wall installation. The Assembly order is shown below.

1. Totally unscrew M6 Torx Sems Screw (2ea) of "B" to separate Wall Mount Bracket from the DU.

(Unscrew M6 Torx Sems Screw (2ea) of "A" only enough for the Wall Mount Bracket to be separated)

2. Place the Wall Mount Bracket and the ∅6.5 Plain Large Washers(4ea) according to the Anchor Bolt

and assemble using HEX, Direct Screws(4ea).

3. Place the SU according to the "Guide & Fixing Groove" picture.

4. Screw back the M6 Torx Sems Screw (2ea) of "B" and re-screw the M6 Torx Sems Screw (2ea) of

"A".

5. Check with the lever bar to confirm that the horizontal/vertical angles are correct.