Parts Manual
1-5
1.5.2 Component Boxes cont.
ITEM PART # COMPONENT
1 8101164 Block, One-Piece Screwless Terminal
2 8160217 Insulation, Terminal Block Paper
√
3 8073843 Fuse 3A 250V Domestic
8073293
Fuse 5A 125V International Only
√
4 8075008 Cable, 21-inch Ignition (Domestic, Australia)
* 8075009 Cable, Ignition 19” (CE)
* 8075266 Cable, Ignition, (Australia)
* 8073484 Connector, Rajah
5 8075165 Cable, 20-pin Controller to 15-pin Interface Board – SMT
6 8066085SP Wire Assembly, Ignitor
7 2206102 Box, One-Piece Component
√
8 8071683 Relay, 15A 12VDC Blower, OIB, Reset Switch
√
8070012 Relay, 18A 24VAC Between OIB Time Delay Board and Gas Valve, (Australia)
√
9 8075691† Ignition Module, Single-Spark Capable Control (CE, Non-CE, CSA and AGA)
8075664† Ignition Module, Single-Spark Fenwal (AGA), (Australia)
10 8075813 Harness, Interface Board to Ignition Module (Capable Controls)
* 1084801 Harness, Interface Board to Ignition Module (Australia)
1086057 Wire Assembly, Full Vat Right (Honeywell)
1086059 Wire Assembly, Full Vat Left (Honeywell)
1086058 Wire Assembly, Dual Vat (Honeywell)
√
11 8262264 Interface Board Kit SMT
8074330 Speaker Adapter Harness SMT
8074343 Wire Harness, SMT Interface Board to Ignition Module
8064973 Interface Board – Australia Only
√
12 8070833
Relay, DPDT 5A 12VDC Latch (See NOTE 1.)
√
13 8070834
Relay, SPDT 15A 12VDC Basket Lift (See NOTE 2.)
14 8102243 Spring, Relay Retaining
15 1086052 Plate, Ignition Module
16 8242090 Cover, Ignition Module
17 8074812
Relay, 7-second Time Delay 120V (U.S., Canadian and Mexico units)
8074934
Relay, 7-second Time Delay 220V, 230V, 240V and 250V units (International units)
* 1060531SP Fuse Assembly, Inline (not used on all models)
* 8072659 Switch, Momentary (Control Power Reset, only used in far left component box)
* 8074403 Speaker SMT
* Not illustrated.
√ Recommended parts.
† For Full-vat and Dual-vat units, use two Single Spark Ignition Modules.
NOTE 1: In full-vat units, only two latch relays (Item 12) are used, located in the sockets on the right side of the
interface board. These relays are located in the bottom sockets of the interface board and control the heating
circuit.
NOTE 2: The relays in the top sockets control the basket lifts.