SPECIFICATION ESD10049826 FSP350-60EGN Released Date:2011/04/18-15:57:57
1/9禁止翻印外洩 文件資料管制 文件資料管制 文件資料管制 SPECIFICATION FSP350-60EGN (GOLD) DATE:DEC,06, 2010 REV：3 表單編號：7000P－010 Page1 ESD10049826-R6.
文件資料管制 文件資料管制 文件資料管制 TABLE OF CONTENTS 1. GENERAL REQUIREMENTS 2. INPUT REQUIREMENTS 3. OUTPUT REQUIREMENTS 3.1 Output Voltage and Current 3.2 Remote ON/OFF Control 3.3 Output Voltage Hold-up Time 3.4 Operation at No Load 3.5 Protection 3.6 Output Rise-Time 3.7 Output Overshoot / Undershoot 3.8 Efficiency Requirement of Main Output 3.9 Efficiency Requirement of Standby Output 3.10 Power-Good Signal Time Sequence 3.11 Output Transient Response 3.12 Capacitive Load 3.13 Closed-loop Stability 4.
文件資料管制 文件資料管制 文件資料管制 1.0 GENERAL REQUIREMENTS This specification describes a 350 watts power supply. With 6 output, and remote ON/OFF control for ATX-12V system and a “Power factor collection (active PFC)” circuit at 100V-240Vac. 2.0 INPUT REQUIREMENTS The AC mains steady-state input voltage shall be 100 to 240 Vrms The power supply shall operate from 90 to 264 Vrms. The power supply shall operate from an AC mains frequency of 47-63Hz.
文件資料管制 文件資料管制 文件資料管制 NO. 1 2 3 4 5 6 7 8 9 10 11 LOAD REGULATION CHARACTERISTICS OUTPUT LOAD LOAD 12V CONDITION +3.3V +5V +12V1 +12V2 -12V +5Vsb COND.1 X X X X X 3.5A COND.2 X X X X X 3A COND.3 0.1A 0.2A 0.1A OA 0A 0A COND.4 21A 1A 2A 2A 0.1A 0.1A COND.5 0.1A 15A 2A 2A 0.1A 0.1A COND.6 2A 2A 14A 14A 0A 0.1A COND.7 3.6A 3.6A 2.6A 2.4A 0.1A 0.2A COND.8 9A 9A 6.5A 6A 0.15A 0.5A COND.9 10A 12A 12A 12A 0.3A 0.05A COND.10 10.89A 7.78A 10.9A 10.9A 0.22A 2.18A COND.11 10A 10A 12A 12A 0.3A 2A Cond.
5/9禁止翻印外洩 文件資料管制 文件資料管制 文件資料管制 3.5.2 Under-voltage protection In the event of an under-voltage condition on +3.3 & +5Vdc &+12V the power supply shall shutdown and require remote control or remove the AC mains input to reset the system. +5V : 4.2V (minimum) +3.3V : 2.6V (minimum) +12V : 10.0V (minimum) 3.5.3 OVER- CURRENT PROTECTION There shall be protection from an output over-current event. The PSU may shutdown form such an event and require power-on restart.
文件資料管制 文件資料管制 文件資料管制 3.7 OUTPUT OVERSHOOT/UNDERSHOOT No output voltage shall overshoot / undershoot or generate spikes at turn-on or turn-off, during momentary power loss, output short, or realistic input voltage or output load changes, Overshoot/undershoot is defined as any output that exceeds the voltage tolerance plus or minus an additional 5%. All outputs shall be measured with minimum load (COND.3) +3.3V +5V +12V -12V +5VSB 3.8 Overshoot 3.63V 5.5V 13.2V -13.8V 5.5V Undershoot 2.97V 4.5V 10.8V -10.
7/9禁止翻印外洩 文件資料管制 文件資料管制 文件資料管制 T1: PS_ON -- DC O/P within Spec.＜500mS T2: RISETIME < 20mS T3: Power Good Delay Time 100mS-500mS T4: Power Good Rise-time＜10mS T5: AC fail hold-up time＞17mS T6: Power Fail Delay Time＞1mS 3.11 Output Transient Response Expected output transient step sizes for each output. The transient load slew rate is = 1.0 A/µs. Table of DC Output Transient Step Sizes Output Max. step size +12V 4A +5 V 4A +3.3 V 4A -12 V 0.1A +5 VSB 0.25A (Adding external capactor of Section 3.
文件資料管制 文件資料管制 文件資料管制 4.0 Physical Environment 4.1 Temperature 4.1.1 Operating Ambient: +0 to 40℃ 4.1.2 Non-Operating Ambient(Storage): －40℃ to +70℃ 4.2 Humidity 4.2.1 Operating: To 85% relative humidity (non-condensing) 4.2.2 Non-Operating: To 95% relative humidity (non-condensing) Note: 95%RH is achieved with a dry bulb temperature of 55℃ and a wet bulb temperature of 54℃. 4.3 Altitude 4.3.1 Operating: To 10,000ft 4.3.2 Non-Operating: To 50,000ft 5.0 Regulatory Compliance 8/9禁止翻印外洩 5.
文件資料管制 文件資料管制 文件資料管制 6.0 Other Requirements 6.1 Input Connections Refer to Mechanical Specifications for placement. The AC mains input are through a three-circuit IEC type connector mounted on the rear of the power supply chassis. 6.2 Reliability The power supply reliability, when calculated by “Bellcore” latest revision are exceed 100,000 hours with all output at maximum load and an ambient temperature of 25℃. The special requirement is for 3years warrenty. 7.
