User manual

24
software, please login first and modify the password. The default password is
“administrator”atfirstlogin. UserscanonlybrowseUPSstatusandinformationas
GueststatuswithoutloginasanAdministrator.GuestcanNOTcontrolorexecutiveany
setting.
Modifypassword
Step1 SelectViewPowerConfiguration>>Password.RefertoDiagram51.
Diagram51
Step2 Enteroldpassword,newpassword,andretypenewpasswordinconfirm
passwordcolumntomodifypasswordforadministrator.(Thepasswordshould
beatleast6digits)Thenclick“Apply”buttontosuccessfullymodifypassword
foradministrator.
NOTE1:Simplyclick“Login”buttononthetoprightcornertologinthesoftware.
NOTE2:Ifpasswordisforgotten,it’snecessarytoreinstallthesoftware.
5.1.2.S MSConfiguration
It’s for entering SMS receiver list. In the event of an alarm condition occurring, a
messageaboutUPSstatuswillbesenttothespecifiedusersviamobilephone.Forthe
eventreceivinglist,pleaseconfigurein“EventAction”column(refertosection514).
Step1 ChooseViewPowerConfiguration>>SMS.RefertoDiagram52.