User manual

29
Step2 Selectaspecificeventfrom“EventList”andthenactionmethodpagewillbe
activeontherighthandcolumn.
Step3 Selectdesiredactionmethodsbyclickingcheckbox.
Step4 Click“Apply”buttontosaveallconfigurations.
NOTE1: Whenediting receiver listinSMSor email columns, it’s necessaryto
refreshtheeventactionpagetoreloadtheupdatedreceiverlist.
NOTE2:Itisrequestedtohavefollowingconditionsforsuccessfulbroadcast.
1. AllreceivingPCsmusthaveinstalledsoftware.
2. OnlysendthemessagetothePCsinLANfoundinUPSNavigation.
5.1.5.WakeonLAN
ItwillmanagethelistforwakeonLANandtestthefunction.
AfteraddingMACaddressofremotePCsintoMAClist,itwillallowremotecontrolthe
PCs.However,it’salsorequiredtohavehardwaresupportforremotePCstoimplement
thisfunction.
Step1 SelectViewPowerConfiguration>>WakeonLAN.RefertoDiagram57.