User's Manual
Table Of Contents
- 1 Introduction
- 2 Safety
- 3 Overview of the Tobii Dynavox I–13 and I–16
- 4 Batteries in the Tobii Dynavox I-Series
- 5 Using the Tobii Dynavox I-Series
- 6 Product Care
- Appendix A Support, Warranty, Training Resources and Trouble-shooting
- Appendix B Compliance Information
- Appendix C Computer Device States of Operation and LED Status
- Appendix D Technical Specifications
- Appendix E Maximum Allowed Temperature
- Appendix F Approved Accessories
5.3.4.1.3.1 Improving Calibration Points
If a calibration point is in need of improvement, follow these steps:
1. Toggle the Select points using gaze On/Off check box to On to gaze enable the calibration points in order to select
them with gaze. (Optional)
2. Select the calibration points to improve.
3. Select the Improve Point(s) button to start the calibration for the selected calibration points.
4. Repeat step 1–3, if necessary.
5.3.4.1.4 Test Calibration
On the Test Calibration page the calibration can be tested, using predefined targets on the screen to see if the user needs
to recalibrate the eye tracker.
1. Look at each dot in each circle on the screen to see how accurate the eye tracking is in that area.
2. Select Close when finished.
5.3.4.1.5 Recalibration
1. Select the Calibration type to use.
For more information, see 5.3.4.1.6 Calibration Type, page 29.
2. Select the Recalibrate button to start a new calibration process for the active profile.
3. Follow the on-screen instructions for performing a calibration.
4. Check out the Calibration Results.
For more information, see 5.3.4.1.3 Calibration Results, page 27.
28
5 Using the Tobii Dynavox I-Series
#12004244 Tobii Dynavox I-Series User’s manual v. - en-US