User`s manual

User’s manual · TSQ 310
- 5 - TSQ 310 version_en_1.1 FTE maximal
2. State of the module
In the option “State of the module” are specified the main parameters of the module at this moment.
- Transmodulator input: It indicates whether the module is hooked or without
signal.
- Input bit rate: Transfers of data in the satellite tuner input.
- Output bit rate: Transfer of data in the module output.
- BER before and after Viterbi: It indicates the error rate of bits of the input
signal before and after the correction produced by Viterbi algorithm.
- MER: Parameter that indicates the quality of the input modulated digital signal,
expressed in dB.
- Noise Margin: It indicates the difference between the value of current C/N
and the value of C/N at the point of pixilation of the signal, that is, the quantity
of dBs of C/N measure that are needed to lose the input signal.
-Temperature: It indicates the current temperature of the module in ºC.
3. Input configuration
In this option you will be able to configure the input parameters of the satellite
signal:
- Local oscillator: Selection of the local oscillator that you wish to use: FI, KU, C,
K9750, K10000, K10600, K10700, K10750, K11250, K11300, K11325.
- Frequency (MHz): Transponder frequency that you wish to tune.
- Symbol speed: Symbol speed required by the transponder.
- Auto symbol rate: You will be able to select if the detection of the Symbol
Rate is going to be Automatic (On) or Manual (Off).
- In Manual mode (Off), the value of the Symbol Rate should be fixed
by the user based on the provider’s information.
- In Automatic mode (On), the meter will automatically identify the SR
when a Satellite carrier is tuned. This feature is very useful when the
provider’s information is unknown.
The SR value found will appear in the field of selection of the SR menu. This value found by the meter could not
correspond exactly to the real broadcast SR, but to a very close value.
Note: The Automatic Symbol Rate feature does not work when the carrier quality is very poor or/and with a very
low Power Level.
- DVB: This option allows selecting the standard DVB of the transponder that you want to tune. Options:DVB-S1,DVB-S2
and auto
- LNB Feeding: In this option you can set the parameters concerning the LNB:
- Voltage RF IN: 13V, 18V and Off.
- Tone 22 kHz: Off, and Auto. In the
- Switch DiseqC: A, B, C, D and Off.