Resyncing Guide

CS-2022 / Rev. No. 1.02

Customers may need to do the re-syncing procedure because they ordered a new handset or received a

replacement handset. In some cases, your handset can lose sync with the CaddyTrek unit. Below are simple

instructions on the re-syncing procedure.

1. Turn OFF the CaddyTrek unit and handset. [figure a]

2. Turn ON the CaddyTrek unit.

3. Then with-in five seconds, turn ON the handset.

4. Immediately after turning the handset ON, press and hold the STOP button while repeatedly pressing the UP

button. [figure b]

5. Continue holding the STOP button while repeatedly pressing the UP button on the handset.

NOTE: Re-syncing can take 5-10 seconds. It may be necessary to restart the process if too much time passes

between turning on the unit and the handset.

6. Successfully re-syncing your handset with your unit will be signified by 2 short beeps coming from the handset.

Your handset will then revert to SB, or Stand-By Mode.

7. Pairing successful! You may now continue using your CaddyTrek.

CaddyTrek Handset Checks

 Check for the overall tactile feel of handset buttons. Are they stuck, loose, or normal?

 Remove the handset battery, and re-insert it. Upon re-inserting the handset battery, you should hear a long

beep sound signifying that both the handset and handset battery are functioning.

 When charging your handset battery, the LED indicator should be red for charging and green for when

charging is complete.

 The LED indicator switches to green when you remove the handset battery while the handset is still plugged in.

 When powering on your handset you should hear a long beep sound. Shortly afterwards, you should hear 2

short beeps that signifies handset pairing.

 To check handset battery levels, hold the orange STOP button.

 Check modes: SB (Stand-By), RC (Remote Control), FL (Follow)

HANDSET PAIRING AND RE-SYNCING GUIDE