- Fuji Programmable Operation Display User's Manual

1. Mounting Procedure 3-1

Installation

1. Mounting Procedure

Mounting Procedure

1. Insert the UG230 into the mounting panel (max. thick: 5 mm).

2. Insert four fixtures attached to the UG230 into the mounting holes, and tighten them with the

locking screws.

Tightening Torque: 0.3 to 0.5 N•m

3. Mount the gasket so that it will be sandwiched securely between the unit and the mounting panel.

Mounting Angle

Install the unit within the angle of 0° to 135° as shown on the right.

Mounting panel

Panel cut-out hole

• Panel cut-out dimensions

(Unit: mm)

17.8

10.5

30.0

Fixture dimensions

(Unit: mm)

Fixtures

Mounting hole

UG230

Mounting

panel

Fixtures

* To prevent static electricity, be sure to

connect the mounting panel to the ground.

0°

135°

90°