User's Manual

2-1
System Configuration (Product Overview)
2
DR-ID 900PU Operation Manual 897N102280A
Chapter 2
System Configuration
(Product Overview)
2.1 DR-ID 900PU
2.1.1 System Confi guration
For the U.S. For other countries
DR-ID 900
DR-ID 900PU
DR-ID 900
DR-ID 900PU
Image processing unit of other digital radiography system
DR-ID 300CL
Flat panel sensor Flat panel sensor Flat panel sensor
Battery
charger
Access
point
Power supply unit
DR-ID 900MP
Control cabinet
DR-ID 900MC
Image
processing unit
DR-ID 900CL
Ethernet switch (Hub)
Access
point
Flat panel sensor
Image processing unit of other digital radiography system
DR-ID 300CL
Flat panel sensor Flat panel sensor
Battery
charger
Power supply unit
DR-ID 900MP
Control cabinet
DR-ID 900MC
Image
processing unit
DR-ID 900CL
Ethernet switch (Hub)
• The products in can be installed in patient environment.
• The FDR D-EVO Advanced consists of the DR-ID 900RU and the image processing unit.
• An access point is used only in wireless communication mode.
* The confi guration of the system varies depending on the country.
• One to four fl at panel sensors can be connected to one power supply unit. If you connect all four
fl at panel sensors in wired communication mode or use them with three different techniques, two
power supply units are required.
• The fl at panel sensor can be used in wireless communication mode or wired communication mode.
• Up to four fl at panel sensors can be connected in wired or wireless communication mode in DR-ID
900PU.
However, either of the following conditions must be met:
a) Two DR-ID 911SE fl at panel sensors are connected in wired communication mode. (More
than three fl at panel sensors cannot be connected in wired communication mode.)
b) Any two of the DR-ID 601SE, DR-ID 602SE, DR-ID 611SE and DR-ID 613SE fl at panel
sensors are connected in wired communication mode.