User's Manual
3-6
Basic Operation
3
Flat Panel Sensors Operation Manual 897N200608
3.2 Starting Up and Shutting Down the
Flat Panel Sensor
This section explains how to start up and shut down the Flat Panel Sensor.
3.2.1 Starting Up
1 Attach a fully charged battery pack to the at panel sensor.
The POWER status lamp on the at panel sensor is lit in blue.
Start up the at panel sensor with the initial settings properly made by our ofcial dealer or INNOLUX Representative.
3.2.2 Performing an Exposure
1
When performing an exposure, make sure that the READY status lamp on the at panel sensor is lit.
3.2.3 Shutting Down
1 Remove the battery pack from the at panel sensor and set the battery pack in the battery charger.
The POWER status lamp on the at panel sensor is lit.