User's Manual

A-2
Appendix A Specifications
Flat Panel Sensors Operation Manual 897N200608
A.1.4 Image Performance
Each at panel sensor complies with IEC 62220-1 (MEDICAL ELECTRICAL EQUIPMENT -
CHARACTERISTICS OF DIGITAL X-RAY IMAGING DEVICES - ) as a general X-ray radiography
equipment.
To ensure optimal image quality, it is recommended that you do not use the at panel sensor near
devices (motor, transformer, switching supply, etc.) that generate electromagnetic noise.
A.1.5 Load Restriction
Entire surface load :
RIC 35G, RIC 43G, RIC 35C, RIC 43C, RIC 24C :
300kg (661.5 lb)
Local load :
RIC 35G, RIC 43G, RIC 35C, RIC 43C, RIC 24C :
120kg (264.6 lb) / ø40mm (1.6in.) (Based on INNOLUX measurement specications)
CAUTIONS
Do not apply an excessive force to the exposure plane.
The sensor inside the at panel sensor may be damaged, and it may not be possible to make
an exposure properly.
A.1.6 Radio Waves
The at panel sensor uses the following types of radio waves.
Flat panel sensor
Wireless specification IEEE802.11n
Transmit frequency 5.2, 5.3, 5.6, 5.8, 2.4 GHz
Modulation OFDM
Frequency tolerance ±20 ppm
Data transfer rate 35 Mbps
Transfer power 17 dBm or less
CAUTIONS
● Transmit frequencies available vary, depending on the country.
● Radio waves available outdoors vary, depending on the country where the system is used.
● When the RIC and any other wireless equipment are operating on the same frequency
channel in a hospital, it may take time to show an image on the image processing unit
monitor.