User's Manual

Document No. : ZST300-078

2016/12/01

1. Introduction

This module is not sold to general end users directly. Therefore there is no user manual of

module itself.

For the details about this module, please refer to the specification of module.

This module should be installed in the host device according to the theory of operation-interface

specification (Installation Procedure).

2. Approvals

FCC

This product is conform to the FCC standards.

FCC Rules (Federal Communications Commission)

This product complies with Part 15 Subpart C of the FCC Rules.

FCC ID : W2Z-03000004

IC (Industry Canada)

IC: 7736B-03000002

FCC/IC NOTICE

This device complies with part 15 of FCC Rules and Industry Canada’s licence-exempt

RSSs. Operation is subject to the following two conditions: (1) this device may not

cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

Le présent appareil est conforme à la partie 15 des règles de la FCC et aux normes

des CNR d'Industrie Canada applicables aux appareils radio exempts de licence.

L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas

produire de brouillage, et (2) l'appareil doit accepter tout brouillage subi, même si le

brouillage est susceptible d'en compromettre le fonctionnement.

FCC CAUTION

Changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

-Consult the dealer or an experienced radio/TV technician for help.