User's Manual

258 Understanding the Printer Menus
Login Error
NOTE: Login Error feature is available only when Panel Lock Control is set to Enable.
Purpose:
To specify the number of error entry attempts allowed when you log in as an administrator in the Admin
Settings and Report/List menu.
Va lu e s:
NFC Authentication
Purpose:
To specify whether to enable the authentication using the NFC authentication card.
Va lu e s:
USB Settings
Use the USB Settings menu to change printer settings affecting a USB port.
USB Port
NOTE: USB Port feature is available only for the USB port on the rear of the printer.
Purpose:
To specify whether to enable the USB port. The change becomes effective after the printer is turned off and then on
again.
Va lu e s:
PS Data Format
Purpose:
To specify PostScript communication protocol for a parallel interface. You can configure the PS Data Format settings
for the wired network. The change becomes effective after the printer is turned off and then on again.
Va lu e s:
Off
*
Does not allow an administrator to log in after one error entry attempt.
On 5
*
Sets the number of error entry attempts allowed when an administrator logs in.
Available Range: 1-10
Disable Does not permit the authentication using the NFC authentication card.
Enable
*
Permits the authentication using the NFC authentication card.
Disable Disables the USB interface.
Enable
*
Enables the USB interface.
Auto Used when auto-detecting the PostScript communication protocol.
Standard Used when the communication protocol is in ASCII interface.
BCP Used when the communication protocol is in binary format.
TBCP* Used when the communication protocol supports both ASCII and binary data to switch
between them according to the specified control code.
Binary Used when no special processing is required for data.