User's Manual

218 Understanding the Printer Menus
NFC Authentication
NOTE: The NFC Authentication feature is available on the Dell Cloud Multifunction Printer | H815dw only.
Purpose:
To specify whether to enable the authentication using the NFC authentication card.
Va lu e s:
USB Settings
Use the USB Settings menu to change printer settings affecting a USB port.
USB Port
NOTE: USB Port feature is available only for the USB port on the rear of the printer.
Purpose:
To specify whether to enable the USB port. The change becomes effective after the printer is turned off and then on
again.
Va lu e s:
PS Data Format
Purpose:
To specify PostScript 3 Compatible communication protocol. You can configure the PS Data Format settings. The
change becomes effective after the printer is turned off and then on again.
Va lu e s:
Job Time-out
Purpose:
To specify the amount of time the printer waits for data to arrive from the computer. The print job is canceled if the time-out
time is exceeded.
Va lu e s:
Disable Does not permit the authentication using the NFC authentication card.
Enable
*
Permits the authentication using the NFC authentication card.
Disable Disables the USB interface.
Enable
*
Enables the USB interface.
Auto Used when auto-detecting the PostScript 3 Compatible communication protocol.
Standard Used when the communication protocol is in ASCII interface.
BCP Used when the communication protocol is in binary format.
TBCP* Used when the communication protocol supports both ASCII and binary data to switch
between them according to the specified control code.
Binary Used when no special processing is required for data.
Off Disables the job time-out.
On
*
30 seconds
*
Sets the time the printer waits for data to arrive from the computer.
Available Range: 5–300 seconds