User's Manual

70 Connecting and Setting Up Your Printer
Configuring the Wireless Settings Without Using Dell Printer Easy Install
WPS-PBC
You can start Push Button Configuration only from the operator panel.
NOTE: WPS-PBC (Wi-Fi Protected Setup-Push Button Configuration) is a method to authenticate and register devices required
for wireless configuration by pressing the button provided on the access point via wireless routers, and then performing WPS-
PBC setting on the operator panel. This setting is available only when the access point supports WPS.
NOTE: Before starting WPS-PBC, confirm the position of the WPS button (button name may vary) on the wireless LAN access
point. For information about WPS operation on the wireless LAN access point, refer to the manual supplied with the wireless
LAN access point.
1 Press the (Information) button.
2 Ta p t h e Tools tab, and then tap Admin Settings .
3 Ta p Network .
4 Ta p Wi-Fi .
5 Ta p WPS Setup .
6 Ta p Push Button Configuration .
7 Ta p Start Configuration .
Ensure that the message
Push WPS Button on router is displayed, and start the WPS-PBC on the wireless
LAN access point (Registrar) within 2 minutes.
8 When the WPS operation is successful and the printer is rebooted, wireless LAN connection setting is completed.
WPS-PIN
The PIN code of WPS-PIN can only be configured from the operator panel.
NOTE: WPS-PIN (Wi-Fi Protected Setup-Personal Identification Number) is a method to authenticate and register devices
required for wireless configuration by entering PIN assignments to a printer and computer. This setting, performed through an
access point, is available only when the access points of your wireless router support WPS.
1 Press the (Information) button.
2 Ta p t h e Tools tab, and then tap Admin Settings .
3 Ta p Network .
4 Ta p Wi-Fi .
5 Ta p WPS Setup .
6 Ta p PIN Code .
7 Write down the displayed 8-digit PIN code or tap Print PIN Code . The PIN code is printed.
8 Ta p Start Configuration .
9 Ensure that the message Operate Wireless Router is displayed, and enter the PIN code displayed on step
7 into the wireless LAN access point (Registrar).
NOTE: For WPS operation on the wireless LAN access point, refer to the manual supplied with the wireless LAN access
point.
10 When the WPS operation is successful and the printer is rebooted, wireless LAN connection setting is completed.