User's Manual Part 1

xiv Saja Operation Manual
10/12/00
Chapter0.fm
Do not attempt to rework, pull, bend, chafe, or otherwise dam-
age the power cord. Do not place a heavy object on the cord. A
damaged cord can cause a fire or shock hazard.
Never touch a power cord with wet hands. Danger of electric
shock exists.
Stop operation immediately if your machine produces smoke,
excessive heat, unusual noise, or smell, or if water is spilt into
the machine. These conditions can result in a fire. Immediately
switch off and unplug the machine, and contact the Xerox Cus-
tomer Support Centre.
To prevent a fire or shock hazard, follow the instruction below
based on your machine configuration. If in doubt, contact the
Xerox Customer Support Centre.
• If your machine is a 220-240V model, there is no need to
attach a separate earth line since the earth connection is
incorporated in the power line. Plug it into a properly rated
outlet.
• If your machine is a 100 or 110V model, use the green earth
wire bundled with the power cord, located at the rear of the
machine.
The earth wire must be connected to one of the following
conductors.
Earth terminal of the specified power outlet
A piece of copper buried in the earth 650mm or deeper
Earth terminal with Class 3
*
earthing.
* Class 3 is the regulation for Japan only.
Never connect the earth wire to any of the following.
• Gas pipe, which can cause ignition or an explosion
• Telephone line earth wire or lightning rod, which can draw
an excessive electric current if hit by lightning
• Water faucet or pipe whose electrical conductivity is broken
by a non-metal part
If the power cord is broken or insulated wires are exposed, ask
the Xerox Customer Support Centre for a replacement. Using a
damaged cord can cause a fire or shock hazard.