Operation Manual

89
The Setup Menu
Menus
v
v
ADD NEW STAMP
ADD NEW STAMP
Copy stamp  les for Q STAMP mode from a
memory card.
Stamp Files
Stamp  les can be found in the “FF_STAMP” folder on
the supplied FinePixViewer CD. Copying these  les
to the camera is a two stage process:  rst, use a com-
puter equipped with a card reader or memory card
slot to copy the  les from the CD to a memory card,
then insert the memory card in the camera and copy
the  les to the camera using v ADD NEW STAMP.
Stamp  les can not be copied directly from the com-
puter to the camera.
Caution
If the installer starts when the FinePixViewer CD is in-
serted in a CD-ROM drive, click Cancel to exit.
1
Insert the memory card containing the stamp
 les in the camera and select v ADD NEW
STAMP in the setup menu.
2
Press the selector left or right to
display the desired stamp.
SELECT STAMP
OK
CANCEL
0 4
SET/ RESET
3
Press the selector up to select or
deselect the current stamp. Se-
lected stamps are indicated by a
check mark.
1 4
SELECT STAMP
OK
CANCEL
SET/ RESET