User's Manual

Rotate Power switch/Volume controller counterclockwise to switch the power OFF.
n Adjust volume
Turn Power switch/Volume controller to adjust volume. Turn it clockwise to increase volume
and turn it anticlockwise to decrease volume.
l When communicating with the other party, it is required to adjust volume accurately.
Note: when regulating the volume, the volume of reporting number is not accordingly controlled.
n Channel Selection
Rotate the channel encoder to selector the desired channel 1—16.
l Reporting number: rotate the channel encoder and the product broadcasts the current
channel in a voice manner.
n Make a call
1. Press and hold the PTT switch and talk to the microphone.
1） Keep the voice source about 3-4cm away from the microphone and talk a normal
tone to allow the receiving station to obtain the best voice quality.
2） The red LED indicator is ON when pressing the PTT switch.
2. Release PTT switch to end transmission and the two-way radio enters RX mode.
n Receiving
When the channel you are using is called, the green indicator is ON. This call can be heard
only when the same frequency and call rule are received.
Functions
n General Settings
1）Device Name
l Set an alias of the two-way radio. A user can input 8 characters at most. Valid characters
include alphanumeric characters, space and special characters. Both Chinese and English
are supported.
2）Programming Password
l A programming password is set to prevent information of the two-way radio being stolen
by others. A user can input 8 characters at most (Valid characters include alphanumeric
characters, space and special characters). It is factory set to 123456.
3）Device ID (equivalent to private call ID)
l The valid set bit for device ID contains 7 digits. Decoding is possible when device ID
matches calling ID of a private call (RX). (it is increased from right to left with the most