User's Manual

3、Set the rem
ote destroy and allow private call only (0******), and remotely
destroy a two-way radio in proper order.
4、Left click “Menu Definition” in the tree view and under the “Address
Book” on the menu editing interface, check "Monitor", “Remote Destroy” an d
“Activation”.
5、Write setting information into the two-way radio through the programming
software.
6、Turn the two-way radio on, and on the manual dialing interface, input device ID to
be remotely destroyed/activated and press “OK” key to confirm it.
7、Press left and right “—” key to select “remote destroy/activation” and
press “OK” key to confirm it.
Emergency alarm
“Emergency alarm mode” is generally defined in orange keys. When the mode is
enabled, the two-way radio will provide dif ferent alarm modes depending on set
emergency alarm mode.
Note: To enable emergency mode, the communication mode of the channel is required
to be set to group call by default.
1、Define ON or OFF of emergency alarm mode via key definition.
2 、 Right click “ Emergency System ” in the tree view and add em ergency
“Alarm 1”.
3、On the channel editing in terface, set “Default Communication A ddress” to
group call and set “Emergency System” to “Alarm *”.
4 、 On the channel editing interface, check “ Emergency alarm indication ” ,
“Emergency alarm confirmation” and “Emergency alarm prompt”.
5、Edit options on the “Emergency System” interface.
FCC Reg
ulations
Federal
C ommunication Commission (F CC) req uires t hat a ll rad io c ommunication products