User's Manual
analog channel to select scan list
●
Scan Hang Time : When a signal is detected on a channel, scan pauses on
that channel, the radio will remain on the busy channel until the signal is no
longer present. When the signal “ drop out” the radio will remain on the
channel momentarily before scan resumes. The delay time is programmed 500
to 10000 milliseconds.
●
Talkback : When a signal is detected on a channel, scan pauses on that
channel, press PTT key can talk back on the channel if enable “Talk Back’
feature; if “Talk Back” isn’t checked, press PTT key may talk back on the
designated channel.
●
TX Designated Channel : During scanning, Press PTT key will transmit on
TX designated channel. You can set TX Designated Channel as Last Active
Channel, Selected channel or a desired channel from scan list.
Auto Scan
If Auto Scan feature is enabled for a channel, the radio will automatically enter
scan mode when it is switched to this channel. To stop scanning, press
programmed Scan On/Off key or switch to other channels. If return to the
channel will enter scan mode directly.
Monitor and Permanent Monitor
Monitor: On digital channel, enable the Monitor feature to monitor current