User's Manual

around” sound; switch to repeater mode, a “repeater” sounds.
Via programmable software to set it:
Channel folder
→
Zone
→
a digital or analog
channel
→ Allow Talk Around
Note：To enable this function, TX frequency should be different from RX frequency, and
the channel will set as allow talk around on the programming software.
TX Power
You can switch power levels to Low or High. If you communicate with radio
located at a distant place please select High power; if you communicate with
radio located at a close place please select Low power to save battery. Press
the programmed High/Low Power key to switch between high power and low
power. Switch to high power, a “high power” sounds; switch to low power, a
“low power” sounds.
Press programmed High/Low power key to switch power level or select power
level via programming software
Via programmable software to set it:
Channel folder
→
Zone
→
a digital or analog
channel → TX Parameters → Power Level
Digital Emergency
In case of an emergency you can enter emergency mode to ask for help, short
press programmed “Emergency on” key to send emergency information, To
exit emergency mode, long press “Emergency off”. On regular type alarm, after
send emergency information then receive ACK command or the alarm cycles
expire, the radio will exit the emergency mode automatically. On silent type