User's Manual
32
RX:136-174MHz，400- 0 M Hz
GENERAL
Frequency
sensitivity
Rated Voltage
Memory channel
Antenna disposition
Antenna impedance
Working manner
5PPm
DC7.2V (rechargeableLi-ionbattery)
Frequency range
SPECIFICATIONS
110mmX56mmX37mm
-122dB(12dB SINAD)
≥60dB ≥55dB
≥65dB ≥60dB
0.5W
<10%
≥85dB
≥65dB
200 channels
Inductivelyloadedantenna
Samefrequencysingleoperation or
differentfrequencysingleoperation
10W/4W/1W
16K F3E/11K F3E
<5k/<2.5kHz
<7uW
6dB
<2.8A(H10)
0.75kHz±50Hz,
0.37kHz±30Hz
12mV
Outputpower
<5%
(wide/narrow)
Intermodulation
TRANSMITTER
RECEIVER
Spurious radiation
Modulation character
Emission current
Spurious rejection
Sensitivity
Audio frequency power
Audio distortion
Blocking
Adjacent channel selectivity
50
All stated specifications are subject to change without notice or obligation.
Modulation mode
(wide/narrow)
Maximum
CTCSS/DCS
deviation(wide/narrow)
Modulation sensitivity
Modulation distortion
TX:1 44-148MHz，420-450M Hz
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment. This device complies with Part
15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
52