MINI NETWORK RADIO USER MANUAL Thanks for your favorite in our network two way radio, wish you enjoy it! Please read this manual carefully before using it.
PACKING LIST No. Item No. Item Radio Belt Clip Battery Hand strap Charger User Manual Product Overview No. Item No.
INSTALLING / REMOVING THE BATTERY ｖ ｗ ｘ To install the battery, put the battery on the back or the radio, as shown in ①②. Push it horizontally along the slot to the top until it clicks. To remove the battery, turn off the radio first , push the bottom battery safety lock and remove the battery as shown in ③. CHARGE BATTERY ｗ ｘ ｖ 1. As ①② shown, connect the charging cable to the power adapter, then connect the power adapter to the AC power outlet. 2.
INSTALL BELT CLIP To install the belt clip, remove the screws from the back of the battery and install the belt clip. INSTALL ACCESSORIES ｖ ｗ Open the jack cover and insert the earphone/programming cable into the radio. Keep covered if not in use.
BASIC OPERATION 1. Power on/off： Long press the "power button" until the screen lights up to power on. Long press the “power button” until the shutdown animation appears to power off. 2. Adjust Volume Rotate the "volume knob" clockwise to increase the volume, rotate counterclockwise to decrease the volume. 3. Transmit To make a call, press and hold the PTT key, then speak into the microphone using your normal speaking voice. Release PTT switch to receive. Hold the microphone approximately 1" from your lips.
CARE AND CLEANING To guarantee optimal performance as well as a long service life of the product, please follow the tips below. Do not puncture or scratch the product with hard objects. Do not place the product in corrosive agents, solutions or water. Do not hold the radio by its antenna or external microphone. When not in use, keep the accessory jacks covered with the protective flap. Power off the product, and remove the battery before cleaning.
FCC Statement: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
