User Manual
18
1
Getting Started
Turning the Flash On and O
Charging
The ready lamp blinks while the ash
charges. The lamp stops blinking
when the ash is ready to re at full
power; if the ash is red before the
lamp stops blinking, ash output will be less than the val-
ue indicated by the guide number (if desired, the ash can
be con gured not to beep when charging is complete;
P
83). Except when camera menus are displayed, you
can test- re the ash (or at some settings, emit a modeling
ash) by pressing the ready lamp (test button).
Standby
If no operations are performed for about two minutes, the
ash will enter standby mode to reduce the drain on the
batteries and the ready lamp will blink slowly. Normal op-
eration can be restored by pressing the ready lamp (test
button).
You can disable this feature or change the time before the
ash enters standby mode (
P
84, 85).