User Manual

31
3
Single Flash Mode
Manual Mode
In manual mode, you can choose the  ash output in frac-
tions of full power, from ⁄ (full power) to ⁄, in steps of
⁄EV (note that depending on shooting conditions, output
may be less than selected if the limits of the camera expo-
sure metering system are reached).
1
Rotate the power switch to ON.
2
Press the page button until the
page is displayed.
3
Press the l function but-
ton to highlight the  ash control
mode.
4
Rotate the command dial to se-
lect B (manual) and press
OK.