User's Manual

3
When setting the headset for pairing mode, make sure the headset is off. Press and hold the
Multi-function button for 3 seconds until the headset is turned on. After the headset is turned
on, it will enter pairing mode automatically. Blue LED pulsing will be displayed in pairing
mode with 2 seconds interval.
On your respective device you should search for the signal and use the device's functions to
connect. On the list of found devices you select "BT-101" to establish the connection.
Some devices require a passcode to connect with a newly established Bluetooth apparatus.
Enter passcode: 0000 if necessary.
When the connection is established, the headset's light indicator will flash a blue light two
times every 5 seconds to verify the connection, there will also be a voice prompt “Connected”.
DISCONNECT THE HEADSET
If you wish to disconnect the established connection between the headset and your respective
device, simply enter the Bluetooth function on your music player and shut down the
connection or switch off the headset.
CLEAR PAIR SETTING
To clear the pairing settings from the headset, you should first turn off the headset. Press and
hold the Multi-function button simultaneously with the Volume down button. The two
buttons has to be pressed and hold for 5 seconds until the red LED flash 4 times and the
headset has now been clear the pairing settings.
RESET HEADSET
To hardware reset the headset, connect to the USB cable to a charging source.