User's Manual
Table Of Contents
- QUICK REFERENCE
- CHAPTER 1 INTRODUCTION
- CHAPTER 2 SETTING UP
- CHAPTER 3 PAPER HANDLING
- CHAPTER 4 PRINTING
- CHAPTER 5 USING SETUP MODE
- HOW TO USE THIS CHAPTER
- ENTERING SETUP MODE
- OVERVIEW OF SETUP MODE
- PRINTING A LIST OF SELECTED OPTIONS
- DECIDING WHICH OPTIONS TO CHANGE
- CHANGING MENU1 AND MENU2 OPTIONS
- CHANGING HARDWARE OPTIONS
- CHANGING PRINT POSITION ADJUSTMENT OPTIONS
- CHANGING CONFIGURATION OPTIONS
- EXITING AND SAVING
- RESETTING DEFAULTS
- USING THE DIAGNOSTIC FUNCTIONS
- SETUP MODE REFERENCE
- ONLINE SETUP MODE
- CHAPTER 6 MAINTENANCE
- CHAPTER 7 TROUBLE-SHOOTING
- APPENDIX A SUPPLIES AND OPTIONS
- APPENDIX B PRINTER AND PAPER SPECIFICATIONS
- CHAPTER C COMMAND SETS
- APPENDIX D INTERFACE INFORMATION
- APPENDIX E CHARACTER SETS
- CHARACTER SETS 1 AND 2 (DPL24C PLUS AND IBM XL24E EMULATION)
- ITALIC AND GRAPHICS CHARACTER SETS (ESC/P2 EMULATION)
- NATIONAL CHARACTER SETS (ALL EMULATIONS)
- NATIONAL CHARACTER SETS (DPL24C PLUS AND IBM XL24E EMULATION)
- NATIONAL CHARACTER SETS (ESC/P2 EMULATION)
- NATIONAL CHARACTER SETS AND SUPPORTED RESIDENT FONTS (ALL EMULATIONS)
- APPENDIX F RESIDENT FONTS
- GLOSSARY OF TERMS
![](/manual/fujitsu-isotec/001m33330a/user-s-manual-english-portuguese/images/img-14.png)
TROUBLE-SHOOTING
7-6 User's Manual
Tips for clearing a jammed sheet from the printer
If a sheet of paper is jammed between the print head and the platen and
cannot be removed, clear it as follows:
1. Turn off the printer and disconnect the power cord from the
receptacle.
2. Push up the locking levers to rlease the forms tractors and open the
paper holders.
3. Move the paper thickness lever to position D.
4. Move the print head so that you can remove the jammed sheet easily
and clear the sheet.
NOTE
The print head is hot immediately after printing. Move it after making
sure that it gets cool.
• If you cannot clear the
jammed sheet by the
above procedure, set
fourfold continuous
forms paper on the
forms tractors and turn
the platen knob to feed
the paper forward. The
jammed paper is pushed
out. Before operation, be sure to position the print head at the
center of the jammed paper.