User's Manual
Table Of Contents
- QUICK REFERENCE
- CHAPTER 1 INTRODUCTION
- CHAPTER 2 SETTING UP
- CHAPTER 3 PAPER HANDLING
- CHAPTER 4 PRINTING
- CHAPTER 5 USING SETUP MODE
- HOW TO USE THIS CHAPTER
- ENTERING SETUP MODE
- OVERVIEW OF SETUP MODE
- PRINTING A LIST OF SELECTED OPTIONS
- DECIDING WHICH OPTIONS TO CHANGE
- CHANGING MENU1 AND MENU2 OPTIONS
- CHANGING HARDWARE OPTIONS
- CHANGING PRINT POSITION ADJUSTMENT OPTIONS
- CHANGING CONFIGURATION OPTIONS
- EXITING AND SAVING
- RESETTING DEFAULTS
- USING THE DIAGNOSTIC FUNCTIONS
- SETUP MODE REFERENCE
- ONLINE SETUP MODE
- CHAPTER 6 MAINTENANCE
- CHAPTER 7 TROUBLE-SHOOTING
- APPENDIX A SUPPLIES AND OPTIONS
- APPENDIX B PRINTER AND PAPER SPECIFICATIONS
- CHAPTER C COMMAND SETS
- APPENDIX D INTERFACE INFORMATION
- APPENDIX E CHARACTER SETS
- CHARACTER SETS 1 AND 2 (DPL24C PLUS AND IBM XL24E EMULATION)
- ITALIC AND GRAPHICS CHARACTER SETS (ESC/P2 EMULATION)
- NATIONAL CHARACTER SETS (ALL EMULATIONS)
- NATIONAL CHARACTER SETS (DPL24C PLUS AND IBM XL24E EMULATION)
- NATIONAL CHARACTER SETS (ESC/P2 EMULATION)
- NATIONAL CHARACTER SETS AND SUPPORTED RESIDENT FONTS (ALL EMULATIONS)
- APPENDIX F RESIDENT FONTS
- GLOSSARY OF TERMS
User's Manual6-6
MAINTENANCE
7. Press the ribbon release levers until the mounting pins snap into the
holes on the ribbon support brackets. Gently pull on the cartridge to
verify that the pins are securely positioned in the holes.
8. Turn the ribbon feed knob clockwise to tighten the ribbon.
9. Move the paper thickness lever back to its original position. For
single sheet printing, the correct position is 1. Table 3.2 in Chapter 3
gives other paper thickness lever settings.
10. Close the front cover of the printer.