User's Manual
Table Of Contents
- QUICK REFERENCE
- CHAPTER 1 INTRODUCTION
- CHAPTER 2 SETTING UP
- CHAPTER 3 PAPER HANDLING
- CHAPTER 4 PRINTING
- CHAPTER 5 USING SETUP MODE
- HOW TO USE THIS CHAPTER
- ENTERING SETUP MODE
- OVERVIEW OF SETUP MODE
- PRINTING A LIST OF SELECTED OPTIONS
- DECIDING WHICH OPTIONS TO CHANGE
- CHANGING MENU1 AND MENU2 OPTIONS
- CHANGING HARDWARE OPTIONS
- CHANGING PRINT POSITION ADJUSTMENT OPTIONS
- CHANGING CONFIGURATION OPTIONS
- EXITING AND SAVING
- RESETTING DEFAULTS
- USING THE DIAGNOSTIC FUNCTIONS
- SETUP MODE REFERENCE
- ONLINE SETUP MODE
- CHAPTER 6 MAINTENANCE
- CHAPTER 7 TROUBLE-SHOOTING
- APPENDIX A SUPPLIES AND OPTIONS
- APPENDIX B PRINTER AND PAPER SPECIFICATIONS
- CHAPTER C COMMAND SETS
- APPENDIX D INTERFACE INFORMATION
- APPENDIX E CHARACTER SETS
- CHARACTER SETS 1 AND 2 (DPL24C PLUS AND IBM XL24E EMULATION)
- ITALIC AND GRAPHICS CHARACTER SETS (ESC/P2 EMULATION)
- NATIONAL CHARACTER SETS (ALL EMULATIONS)
- NATIONAL CHARACTER SETS (DPL24C PLUS AND IBM XL24E EMULATION)
- NATIONAL CHARACTER SETS (ESC/P2 EMULATION)
- NATIONAL CHARACTER SETS AND SUPPORTED RESIDENT FONTS (ALL EMULATIONS)
- APPENDIX F RESIDENT FONTS
- GLOSSARY OF TERMS
Interface
D-3
User's Manual
INTERFACE INFORMATION
Pin Return Signal Direc- Description
No. Pin No. name tion
1 19 Data Strobe Input This signal is a strobe pulse
(DSTB) for reading data (Data 1 to 8).
The printer reads data when this
signal is low. The pulse width
must be 1 µs or more at the
receiving terminal.
2–9 20--27 Data 1 to 8 Input Data 8 (pin 9) is the most
significant bit; however, this pin
is not used in 7-bit ASCII
communications.
Logical 1 signals must go high at
least 1 µs before the falling edge
of the Data Strobe signal and
must stay high for at least 1 µs
after the rising edge.
10 28 Acknowledge Output This pulse signal indicates
(ACK) that the printer has received data
and is ready to accept the next set
of data.
This signal is also sent when the
printer is switched from offline to
online.
11 29 Busy Output Data cannot be received when
this signal is high. This signal is
high during data entry, when the
printer is offline, when the buffer
is full, or when an error occurs.
12 30 Paper Empty Output This signal is high when the
(PE) printer is out of paper.
Compatible Mode