User's Manual
Table Of Contents
- TABLE OF CONTENTS
- Quick Reference
- CHAPTER1 INTRODUCTION
- CHAPTER2 Setting Up
- CHAPTER3 Paper handling
- CHAPTER4 Printing
SETTING UP
User's Manual 2-11
Quick
Reference
Introduction
Setting Up
P
aper
Handling
Printing
Setup Mode
Looking at the printer from the back with the cut sheet stand and back cover
removed, you can see the following parts of the printer:
Ejection cover
Interface
connecto
r
Paper select lever
Power
connector
Forms tractors
Back cover
Paper guide
Printer components (rear)
Before you plug in the printer:
√ Make sure that the printer power is switched off. The side marked “1”
on the power switch should be raised.
√ Make sure that the power outlet is properly grounded.
√ Make sure that you use the power cord shipped with the printer. This
cord is designed to minimize radio frequency interference.
CONNECTING THE POWER
CORD