User's Manual

USING SETUP MODE
5-38 User's Manual
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG
Items
Options Description
<TEARPOS> Tearoff position.
VISIBLE
Select this option when your software
positions forms to the next top-
ofform after printing the last data.
The printer performs tearoff feed
without adding a form feed when data
transfer has stopped.
ALWAYS
Select this option when your software
stops after printing the last data. The
printer performs tearoff feed after
adding a form feed when data transfer
has stopped.
Note: For both settings, tearoff
positioning will fail if the page
length setting does not match the
actual perforation spacing.
The following <TEAR-EN> item is printed when TEAROFF:AUTO is
specified for the <TEAROFF> item.
<TEAR-EN> Tearoff enabled time (offset time).
0 SEC
1 SEC
2 SEC
4 SEC
6 SEC
The offset time is from when data
transfer stops to when the printer
performs automatic tearoff feed.
If the printer receives data again
within the offset time, the printer
does not perform automatic tearoff
feed.