User's Manual

USING SETUP MODE
5-46 User's Manual
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG
Items
Options Description
<CNT-LD>
Selection for the paper feeding of
continuous forms paper
PRCISIN Gives a higher priority to precision.
SPEED Gives a higher priority to speed.
<CSF-LD>
Selection of the method of feeding
from the CSF
NORMAL
Feeds paper directly from the CSF
hopper.
SWBACK
Feeds paper from the CSF hopper to
either the cut sheet table used with a
front CSF or the stacker used with a
rear CSF. Then, that paper is fed
again.
<CSFAPTC>
Paper thickness detection with use of
a CSF
ALWAYS Every sheet of paper that is fed
NORMAL
Sheet of paper that is fed immediately
after the feed pin is switched
<LF-CTL> Selection for page return
PRCISIN Gives a higher priority to precision.
SPEED Gives a higher priority to speed.
<PR-MODE>
Selection for print mode
(standard/low noise)
NORMAL Prints in standard mode.
QUIET Prints in low-noise mode.
<HI-IMPT>
Selection for high printing pressure
mode
DISABLE Prints in standard pressure mode.
ENABLE Prints in high printing pressure mode.