User's Manual

USING SETUP MODE
5-32 User's Manual
Table 5.5 HARDWAREItems and Options (Cont.)
NOTE: Underlined options are the factory defaults.
HARDWARE
Items
Options Description
<BUFFER> Assigns buffer memory to input data and
downloaded font data.
Print buffer Download buffer
NONE 0 byte 128K bytes
256BYTE 256 bytes 127.75K bytes
2KBYTE 2K bytes 126K bytes
8KBYTE 8K bytes 120K bytes
24KBYTE 24K bytes 104K bytes
32KBYTE 32K bytes 96K bytes
96KBYTE 96K bytes 32K bytes
128KBYT 128K bytes 0K bytes
NOTE:
 0BYTE option is recommended only
for graphics application.
 With 128KB selected, the printer
cannot accept any download font data.
<SENLEVL> ## % 120, 110, 100, 90, 80, 70 or 60 %
The threshold level of Photo Sensor for Paper
Edge Detection.
If output voltage of photo sensor is not
enough, threshold level should be lower so
that sensor can detect paper properly.
In general reasons of low voltage of sensor
output are as follows.
・Paper color is too dark.
・Preprint is on scanning area.
Note
The margin for strong light from outside
would be decreased, if you select threshold
level lower than 100% (90,80,70 or 60%).