User's Manual

USING SETUP MODE
5-38 User's Manual
Table 5.6 ADJUST Items and Options (Cont.)
NOTE: The top of form position is out of paper at [-1/6 IN] and [0/6 IN].
When printing, set the margin more than 1/6inch.
ADJUST
Items
Options Description
<FCUTORG> -1/6 IN
0/6 IN
1/6 IN
1.8/6 IN
:
6/6 IN
:
66/6 IN
Sets the top-of-form for front single
sheets in increments of 1/6 inch (4.2
mm) from the physical top of the page.
The default is recommended if your top
margin is not software-specified. A
setting of 1/6 inch is preferable when
your top margin is software-specified.
<FCUTFIN>
0/180, ..., 29/180
Fine-tunes the top-of-form position for
front single sheets.
Increases top-of-form in increments of
1/180 inch
(0.14 mm).
<RCUTORG> -1/6 IN
0/6 IN
1/6 IN
1.8/6 IN
:
6/6 IN
:
66/6 IN
Sets the top-of-form for rear single
sheets in increments of 1/6 inch (4.2
mm) from the physical top of the page.
The default is recommended if your top
margin is not software-specified. A
setting of 1/6 inch is preferable when
your top margin is software-specified.
<RCUTFIN>
0/180, ..., 29/180
Fine-tunes the top-of-form position for
rear single sheets.
Increases top-of-form in increments of
1/180 inch
(0.14 mm).