User's Manual

USING SETUP MODE
User's Manual 5-43
Table 5.6 ADJUST Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
ADJUST
Items
Options Description
<FCNTCUT>
71 /180, 74 /180,
78 /180, 81 /180,
85 /180, 88 /180,
92 /180, 95 /180,
99 /180, 102/180,
106/180, 109/180,
113/180, 116/180,
120/180, 124/180,
128/180, 131/180,
135/180, 138/180,
142/180
It is possible to set the amount of blank
area of both sides of the front continues
form.
This setting is effective only for the
front continues form at <
FCNTARE:ENABLE1 or ENABLE2>
<RCNTCUT>
71 /180, 74 /180,
78 /180, 81 /180,
85 /180, 88 /180,
92 /180, 95 /180,
99 /180, 102/180,
106/180, 109/180,
113/180, 116/180,
120/180, 124/180,
128/180, 131/180,
135/180, 138/180,
142/180
It is possible to set the amount of blank
area of both sides of the back continues
form.
This setting is effective only for the
back continues form at <
RCNTARE:ENABLE1 or ENABLE2>.
<CUT-CUT>
7 /180, 10 /180,
14 /180, 17 /180,
20 /180, 24 /180,
28 /180, 31 /180,
35 /180, 38 /180,
43 /180, 46 /180,
50 /180, 53 /180,
57 /180, 60 /180,
64 /180, 67 /180,
71 /180
It is possible to set the amount of blank
area of both sides of the cut sheet paper.
This setting is effective only for the cut
sheet paper at < CUT-ARE:ENABLE1
or ENABLE2>.
<FRCSLNT>
7 /360, 14/360,
21/360, 28/360,
35/360
It is possible to set the threshol
d
of
skew detection during manual paper
insertion of a cut sheet.